Where is the airbag module located?
In some vehicles, it is located in the center console, kick panel, under the radio, or behind the steering wheel. Generally, though, it can be found underneath the driver’s seat or front passenger’s seat. Heavy-duty vehicles such as buses and trucks have engine control modules instead of airbag control modules.
Where is SRS unit located?
First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min.
Do airbags need coding?
New Airbag Controllers in many VW/Audi vehicles contain a Soft Coding of all zeros from the factory and must be coded once they have been installed in the vehicle. Always save a complete [Auto-Scan] prior to removing the original Airbag controller.
What is a VCDS tool?
VCDS is a software package for Windows that emulates the functions of the dealers’ very expensive proprietary scan tools. To see what functions it can perform as compared to the dealers’ tools, check out our Function Chart.
Can I remove an airbag control module?
Steps to remove airbag control module In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs.
Do airbags have a fuse?
The airbag in your vehicle likely a fuse but the fuse does not activate the air bags. Additionally, if your service airbag lights are on, your entire system will be inoperative.
How much does it cost to reset airbag module?
At the very least, the ECU or airbag module will need to be reset costing about $50 to $150. If the airbag control module needs replacing, expect to pay anywhere from $400 to $1,200 for a new one.
Where is the airbag control module located in a car?
Generally, though, it can be found underneath the driver’s seat or front passenger’s seat. Heavy-duty vehicles such as buses and trucks have engine control modules instead of airbag control modules. These units are often located beneath the instrument panel glove box on the front passenger side of the vehicle.
How do you install the airbag module on a Honda Accord?
This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs. Wait 3 minutes before installing the airbag module in the vehicle.
Why do I need to Reset my airbag control module?
Even after a minor accident the airbag may not deploy but the seat belts will lock and airbag module will need to be reset because of crash data and crash codes that are stored in the airbag module. MyAirbags will reset your airbag control module back to its original manufacturer state clear of all codes, both soft and hard codes.
What is an SRS airbag module?
An airbag control module is the mechanism that controls the airbag system. There are several airbags in a vehicle, some located in the front, on the sides, or on knee-level to passengers. However, there is only one SRS airbag module unit in a vehicle.