What setting should my subwoofer be on?
If you’re using the subwoofer in a stereo or computer system, just set the subwoofer volume so that it sounds the best from the chair you usually sit in to listen. The sound should be neither boomy nor thin. You can also change the subwoofer volume on the fly to suit whatever music or movies you’re listening to.
What should I set phase to on subwoofer?
Setting the phase control to 180 degrees reverses the polarity of the subwoofer. In some application where the subwoofer is placed on a wall opposite from the speakers, reversing the subwoofer polarity can yield better in-room low frequency response.
Why is my amp working but not my subs?
You have to check the settings of the speaker to ensure that the subwoofer is enabled. Therefore, go to Settings> Speaker> Speaker SP and check the speaker pattern. If the pattern ends with 1 or 2, then it is ok. If the pattern ends with 0, then your subwoofer won’t work.
Why does my amp turn on but no bass?
You need to make sure that the amp receives an input signal from the head unit via speaker level inputs (high-level inputs) or RCA level inputs (low-level inputs). In order to verify this, disconnect the input cables and connect your head unit with amp using a new pair. Then turn the head unit on with volume up.
How do I get power to my subwoofer?
Run the power cable from the battery to the subwoofer. Lower the wire down into the engine compartment and through the firewall hole until it emerges inside your car. Then, go inside your car to pull it all the way to the subwoofers.
What number should subwoofer be?
A subwoofer is like a low-frequency driver for your main speakers—just one that is separated on its own. Set the crossover at a frequency where your main speakers can comfortably handle the audio above the crossover point. The subwoofer takes care of everything below that point. THX recommends 80Hz for most systems.
How do I position my subwoofers correctly?
To do this correctly, you must position your ears at the height the subwoofer driver will be at when moved into its final position. That’s why it’s called the crawl!
How to setup a subwoofer for bass?
Subwoofer Setup: How to Get Great Bass in 3 Steps 1 Step One: The Subwoofer Crawl#N#Due to the way room modes vary in their distribution, proper placement of a single… 2 Step Two: Manually Measure More
How do I do the subwoofer crawl?
To do the crawl, you first position the subwoofer at your listening location (elevated to ear height, not on the floor!). Next, while playing a slow low-frequency sweep tone available on many test CDs (and online at audiocheck.net), move around the room listening for the smoothest response as the sweep moves up and down the scale.
Should you add a subwoofer to your home speakers?
But the truth is that adding a modest but well-designed subwoofer to speakers, even compact bookshelf models, can result in better performance than what you’d get from full-range towers that cost considerably more. Full-range speakers present a room-friendly option, particularly for dedicated two-channel systems, and can sound very good.