How do you load Bostitch staples?

Grasp the arm and close it down over the carrying tray. As you move the arm downward, you will feel the tension of the hinge return. Push down forcefully on the the arm to make a test staple. The stapler is now loaded and should be ready for use.

How do you load a Bostitch stapler 1500?

Most of our staplers load using the simple, four-step process below.

1. Flip. Flip the stapler upside down and open the base away from the body.
2. Pull. Pull the magazine pusher back to expose the staple channel.
3. Drop. Drop the staples into the magazine channel with the points facing up.
4. Push.

How do you load a Bostitch T5 staple gun?

Bostitch staplers, such as the Bostitch T5, load from the front of the magazine. The magazine cover is located right next to the aperture through which the staples exit when you shoot them. Lift the cover to unhook it and tilt it open.

How do you load a Bostitch T5 stapler?

Bostitch staplers, such as the Bostitch T5, load from the front of the magazine. The magazine cover is located right next to the aperture through which the staples exit when you shoot them.

What size staples does a Bostitch T5 stapler use?

Bostitch STCR2619 type staples, also known as Bostitch T5 staples. 7/16 Crown, 24 Gauge. Galvanized and stainless steel staples. Divergent staples with leg length 1/4, 3/8, and 1/2-inch available.

What staples fit a Bostitch T15?

Felt staples 21 gauge stcr5019 length 3/8 inches count=5m Fits Bostitch: P6C-8,H30-8,PC4000,PC5000, T15,T15C,T58D4, JK:694, Prebena: HHD-10, Rapid:31.

How do you reload a Bostitch nailer?

How to Load Nails in the Bostitch Nail Gun

1. Disconnect the nail gun from its power source.
2. Turn the nail gun upside down.
3. Lift the slide latch located at the rear of the nail gun.
4. Pull the slide away from the nail gun while keeping the slide latch lifted.
5. Note the arrows that appear on the slide.

What staples fit a Bostitch T5 stapler?

How do you load a Bostitch heavy duty stapler?

Loading a heavy-duty Bostitch Staple Gun is different from loading a standard-sized Bostitch staple gun.

Locate the follow block release clip at the rear base of the Bostitch staple gun.

Push in the clip while at the same time pulling the block out and away from the arm of the staple gun and the magazine.

How to load a top load staple gun?

Unlike manual staple guns that are rear loading,electric guns are bottom loading.

In some cases,your staple gun might not have a trigger.

Find the magazine release buttons at the back of the staple gun.

In some cases,you might be confused about tackling the magazine that holds the staples.

How to load a Swingline staple gun?

Load the Swingline staple gun by removing the spring loaded push bar located on the back of the stapler’s handle. Slide the staples into the stapler, and then replace the push bar, locking it in place.

How to load staples into a staple gun?

Turn off the compressor and detach the stapler. Disconnect the stapler by switching the power button on the back of the compressor tank to the “off” position.

Push on the lever at the front of the gun to disconnect the follower.

Lay a strip of staples over the magazine rail with the legs facing down.