How do I reset my WLC to factory settings?

Via GUI:

1. login to WLC GUI with valid username and password.
2. Go to Command > Reset to Factory Default.
3. Click Reset.

How do I reset my Cisco AP 2700?

Reset Cisco Wireless AP to factory defaults

1. Connect the console cable.
2. Unplug the power or network cable if connected to a POE switch.
3. Press and hold the Mode button.
4. Plug the power back into the AP.
5. Wait until the output on the console says button is pressed.

How do I access my Cisco wireless controller?

Both the wired and wireless clients can access the dynamic interface of the controller using the CLI and GUI. To access the GUI of the controller enter the dynamic interface IP address of the controller in the address field of either Internet Explorer or Mozilla Firefox browser.

How do I reset my Cisco wireless Router?

The default username is cisco and the default password is cisco. Step 1. Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

How do I Reset my Cisco wireless Router?

What happens when you Reset your wireless router?

Resetting your router will completely wipe any configurations you’ve saved and restore your router to its factory default settings. That means you’ll have to set up your password, network name (SSID), and more all over again.

How do I change my Cisco WLC password?

Cisco 4400 Series Wireless LAN Controllers – How to Recover the Password on a WLC

1. After the controller boots up, enter Restore-Password at the user prompt.
2. At the Enter User Name prompt, enter a new user name.
3. At the Enter Password prompt, enter a new password.
4. At the Re-enter Password prompt, re-enter the new password.

How do I access my WLC GUI?

To access WLC GUI, we can use HTTP/HTTPS over a browser. Here, service port interface or the management interface is used to access GUI. To access GUI, 192.168. 1.1 is the default IP Address.

How do I Reset my wireless access point?

Resetting the access point using the Reset button Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid.

How do I set up the Cisco 2500 series wireless controller?

The Cisco 2500 Series Wireless Controller defaults are Read-Only community public and Read-Write community private. Add new communities or modify as necessary. For simplicity, the defaults are used. In the PI interface, select Operate > Device work center. Select Add device from the menu bar.

How to connect a Cisco 2500 series controller to catalyst 3560 switch?

A simple topology has the Cisco 2500 Series Wireless Controller connected to a Catalyst 3560 switch. Gigabit Ethernet port 1 on the controller is connected to Gigabit Ethernet port 1/0/1 on the switch. Building configuration… !

How to configure SNMP for the Cisco 2500 series wireless controller?

Note that this might differ dependent upon if you use the classic theme from PI or if you ucs NCS or WCS. Enter the IP Address of the Cisco 2500 Series Wireless Controller management interface and configure the appropriate SNMP parameters. Click OK.

Where is the Gigabit Ethernet port on the Cisco 2500 series controller?

Gigabit Ethernet port 1 on the controller is connected to Gigabit Ethernet port 1/0/1 on the switch. Building configuration… ! The management interface configuration on the Cisco 2500 Series Wireless Controller is straightforward and has dynamic AP management enabled.