What does staging mean in drag racing?

Staging consists of two sets of lights, pre-stage and stage. There is a roll-out distance between the sensor for the pre-state and staging lights. You normally light the pre-stage lights first then roll through your roll-out to light the stage lights.

What is the advantage to deep staging in drag racing?

Deep staging allows you to trigger the ET clock much sooner and puts you physically closer to the finish line; the result is improved reaction times at the expense of elapsed time. Deep staging requires plenty of practice and is not recommended for beginner racers.

What is deep staging in NHRA?

Deep staging is the practice of rolling forward enough to turn off the prestage light. The thought behind this is you are closer to the finish line than your opponent.

What is the average reaction time for a drag racer?

In the Pro Stock category, Rickie Jones and Greg Stanfield have average reaction times of 0.022 and 0.024 respectively, but Jones is 10th and Stanfield is fifth in the points standings. Points leader Mike Edwards — who has a 245 point lead on second place — has an average reaction time of 0.043 and is 16-13-1.

What does pro tree mean in drag racing?

The first type which is mainly used by the NHRA Pro drag racing is called the Pro Tree. The Pro Tree is when all three amber lights flash simultaneously followed four-tenths of a second later by the green light ( green is when you gas the vehicle forward).

What does Tree mean in drag racing?

You could also say: ‘Tree. Definition: The starting line light fixture that lets racers know when the car is properly positioned for a start and when to start. Trees often have the following bulbs: Pre-staged and staged (yellow), countdown (three amber bulbs), start (green bulb), and foul start (red bulb).

Why is there a deep stage in drag racing?

If you roll further forward and uncover the stage beam, you will redlight and be disqualified. Deep staging allows you to trigger the ET clock much sooner and puts you physically closer to the finish line; the result is improved reaction times at the expense of elapsed time.

What do they spray on a drag strip?

PJ1 TrackBite
Competition drag strips use a resin-based compound called PJ1 TrackBite (formerly known as VHT) that gets sprayed onto the asphalt to create a sticky surface for impressive launches. Hey, when a car’s horsepower count is deep into the four digits, it needs all the help it can get to hook up and go.

How do I get better at drag racing?

If you are going to be stock car racing, make sure you remember safety first, and then use these drag racing tips and techniques:

1. Look through As Far Ahead As Possible:
2. The Burnout:
3. Tire Pressure:
4. Brake with Your Left Foot:
5. Pre Race Prep:
6. Don’t Steer, Brake, and Accelerate at the Same Time:
7. Visit Roadrunner Performance.