How do you take a fan pull switch apart?
Unscrew the nut on the side of the fixture that holds the switch. Look on the outside of the fixture for a small nut. Unscrew this nut to remove it completely, letting you access the ceiling fan pull chain switch. Set the nut aside for safekeeping.
Why is my fan switch not working?
If the switch fails to operate the fan, try pulling the fan chains first. If the fan still fails to operate and you have the switch in the “On” position, there could be a faulty connection somewhere between the circuit breaker, the wall switch and the fan.
How can you tell if a pull chain switch is bad?
If there are no loose wires visible, the culprit is likely a faulty pull chain switch. To check, turn off the power at the breaker box, and disconnect the wires coming from the switch to the lights. Be sure that the wires are not touching anything before you turn the power back on, and test the wires with a voltmeter.
How do you reset a Hunter ceiling fan?
Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Press and hold both the ‘FAN’ and ‘LIGHT’ buttons for at least four seconds. This step should be done within three minutes of restoring power to the fan.
How do you test a pull chain switch?
How do I turn on my Hunter ceiling fan without a remote?
To turn it on without a remote, all you have to do is purchase a long pull cord to add to the pull switch, so you can operate it without struggling to reach the pull switch or even fumbling for the remote.
Where are the DIP switches on a Hunter fan?
The DIP switches are under the battery compartment on the remote and are on the flat side of the receiver.
How do I know if my switch is bad?
Signs It’s Time To Replace Your Switch
- Your lights don’t turn on, take a minute to turn on, or flicker, and putting a new bulb in doesn’t fix it. It’s common that some bulbs, like the incandescent tube lights, take a minute to turn on.
- The switch makes noise.
- Sparks.
- It’s warm to the touch.